UNIPUMP news: NOVELTY: UNIPUMP-BEF flow water heater tap
Eng | Ru

NOVELTY: UNIPUMP-BEF flow water heater tap

15.08.2016

Dear partners,

UNIPUMP presents the novelty — UNIPUMP-BEF flow water heater taps.

UNIPUMP flow water heater

Why do you need it?

This is a tap which looks like a common mixing faucet but inside it there is a heating element allowing to heat water flow passing through it and delivering warm water to consumer in a few seconds after switching this tap on. The heating element starts to heat water as soon as a control knob is turned to "HOT" (red, left position). Such tap allows heating cold flow water for domestic purposes. This is especially important in premises to which there is no possibility to conduct hot water or install water heater. For example, in house or on land plot: household sink, summer kitchen or wash basin. Such tap is very helpful for distant water consumption points where it is unreasonable to conduct hot water. The water heater tap is not designed for operation in unheated premises; it is connected to cold water supply system with pressure of 0.04-0.5 MPa and household electrical network of 220 V, 50 Hz.

What does it consist of?

The flow water heater tap consists of a body (1) with a heating element inside it, a swivel spout with a mesh aerator (2), a control knob (3) and an electric cable with a plug (4). Cold water is heated by an electrical heating element located inside the housing. Pressure sensor, built in the heating chamber, shuts off the heating element power at minimum pressure of 0.04 MPa (0.4 bar) in cold water supply system. The heater tap is not transferred to heating mode when there is no water in cold water supply system or pressure is too low. Depending on the model, on the housing there is either a digital display showing water temperature (5) or a heating mode light-indicator (6).

How does it operate?

The control knob allows to control three operating modes:

“OFF”. The control knob is in the center position: the tap does not operate, no water flow, the heating element is switched off.

“HOT”. The control knob is turned to the left: the heating element is switched on; hot water will flow in a few seconds. Temperature can be adjusted by increasing or decreasing pressure head.

“COLD”. The control knob is turned to the right: the heating element is switched off; only cold water flows.

Attention! The function of hot and cold water mixing is not applicable for flow water heater. Temperature can be adjusted only by increasing or decreasing pressure head.


What models does UNIPUMP offer?


BEF-001 flow water heater tap: the ring - light indicator made of blue plastic; the housing material - plastic. Power: 3 kW.





BEF-017 flow water heater tap: the ring - light indicator made of lilac plastic; digital display with temperature indication; the housing material - plastic. Power: 3 kW.





BEF-012-02 flow water heater tap: digital display with temperature indication; the housing material - plastic. Power: 3 kW.





BEF-016-03 flow water heater tap: digital display with temperature indication; the housing material – plastic; stainless steel simulated. Power: 3 kW.





BEF-003-178 flow water heater tap: heating mode light indicator; the housing material - stainless steel. Power: 3 kW.





Obvious advantages

No need to wait till water heats up: hot water will come in a few seconds after the tap is switched on.
Flow water heater is easily mounted like a common mixer; it does not require additional space or special skills to install it.
The water heater tap is a reliable and safe device which allows arranging comfortable water consumption.
All models of modern design will add style to any interior.



← All News